Super Lube Silicone Heat Sink Compound - Thermally Conductive for Heat Transfer - High Dielectric Strength Thermal Compound - Ideal for Electrical Devices & Components - White - Tube - 3 oz (98003)

This is a great product and a great value! I used this to repair a coffee machine, and placed this thermally conductive paste between the heating element and the hot plate. It has been working really well so far and it's been about 6 months.

Used this when repairing my Mr. Coffee coffeemaker (heating element to hot plate interface, and thermostat to heating element interface). Is working fine. This tube will probably last me for the rest of my life.

Good deal fast shipping thanks

Seems like good stuff

The best!

The 3 oz. tube of Super Lube 98003 Silicone White Heat Sink Paste showed up quickly and without any problems with this part of the order. Yes, that's a hint, but it doesn't apply to this item and seller! I have numerous LED lights in which the mfgrs. either failed to use heat sink paste between the rear of the LED board and the heat sink / chassis, or just applied a little smear that doesn't even cover 20% of the heat sink contact area: It's no wonder LED lights have gained a bad rap for not making it to even 1/2 of their rated lifetimes. Right off the bat, I have two LED Bay lights that actually have a nice, good heat sink, but no paste between the Aluminum back of the LED board, and the contact area of the heat sink. I'll run a 10 minute test to see how warm the heat sink gets, then I'll pull 'er back apart, apply this heat sink paste, and re-test. If results are good, as I expect, I'll upgrade this rating to 5 stars. This paste may not meet the specs for high end CPU cooling (which if problematic is likely more a problem of inadequate heat sink area, than the efficacy of the heat sink compound). However, it should be fine for most electronics purposes. Design hint for Super Lube and LED light manufacturers: While neither a clear high temp silicone grease nor glass have the best heat conduction in the world, quite a lot could be done on the FRONT side of LED boards to conduct away heat. You'd lose a little light output passing through the grease, but likely no more passing through the glass than you do through plastic, and since LED efficiency is better when they are not hot, the end output would likely be at least as good as typical designs. The big gain would be in fewer failures and returns. Careful engineering would reduce the amount of glass and clear heat sink paste needed, and rear heat sinking could probably be reduced.

Just what I needed, great price and fast shipping. Thank you

This is just what I was looking for , its fairly priced I now have enough for all my known and unknown future projects.

Perfect, as described, quick shipping

Lo utilicé para algunos aparatos que se notaban muy calientes, uno de ellos se apagaba por sobrecalentamiento, resulta que la pasta térmica estaba completamente seca, desarmé, limpie con alcohol isopropilo, aplique este producto y rearme, nada de problemas ahora, conduce bien el calor y con el paso de aire de ambiente se mantiene a buena temperatura (enfriamiento pasivo). Recomendado!

Lo apliqué al procesador de una computadora gaming y funcionó correctamente, bajando un poco la temperatura del procesador. Ahora es cuestión de que no se seque pronto. Actualizaré este comentario si observo que se seca demasiado rápido.

Use this to install cartridge type block heaters (e.g.Toyota)

Buen producto