9-45001R

Considering how expensive stuff has gotten I decided to buy this “off brand” impeller for our Moomba. Figured at this price I could replacement yearly (if need be) vs. every other year.What sold me was a review saying they had it for two years. I’ll update when I its time to replace it.Exact fit, exact look. Went in as any other one would. Fins felt pretty good.On the old impeller has 200+ hours on it. Not much wear.

Looks like a quality part, have not installed yet. Kept for spare.

Works as designed in a 1997 Wellcraft 175ssx 4 cylinder Iron Duke. Used Dawn soap on the entirety of the unit while installing and made ease of installation perfect.

I happened to take the water pump apart on my 2004 Volvo outdrive and found one of the impeller blades was missing (this after 18 years and 125 hours on the engine). No clue where the piece went...into the engine cooling system? Anyway, purchased this impeller and it fits just fine. I note that directions say the impeller "should be changed every year".. Duh! Since it hasn't been used yet (the water is still ice here in NH) I can't say how long it will last.

Sizing is correct. Will not know life expectancy until end of season.

All of the older '00 era mastercrafts with direct drives and indmar engines use the Johnson raw water pump this impeller fits. The splined impeller itself was a perfect fit and the kit came with the right gasket too. Very happy and glad this was in stock as the oem impeller is suddenly hard to find. Grateful for this, keeps me on the water!

I just installed the 2nd impeller of this brand, meaning I just removed the 1st one after two years and 200 engine hours of service in my Indmar 320 LCR in my 2008 Malibu VLX. Not a single crack, chip or chunk out of the rubber fins. The brass hub looks great and rust free, and the rubber hub material looks brand new as well. For the price, I wouldn’t test this theory, but I would expect you could get 500 hours out of this impeller! Extremely impressed with the wear and durability. I won’t be going back to Johnson OEM rubber again.

This product fit well and was not very hard to install. I watched a Youtube video for instructions. Then I pushed and twisted it in the proper direction until the splines engaged, then pushed it in completely. Next time I will buy an impeller puller. It took about 45 minutes of pulling to remove the old one.