TORMEKSVD-185 Universal Gouge Jig

• The TORMEK SVD-185 gouge tool solves the problem of "V" gouge and chisel sharpening, turner and sculptor tools, including complex tools: angled, elbow, spatulated..
• Design of the device for gouges TORMEK SVD-185 The device consists of a tool holder (1) articulated around a guide (2). The tool is straightened by a pad (4) and locks using the screw (5). For wide gouges, use a washer (6). To achieve a convex edge, the locking ring (7) is adjustable using a button screw (8). The tool holder tilts and locks.
• 7392485002772.
• SVD-185.

With the Tormek patented SVD-185 you can sharpen your woodturning gouges to a razor sharpness with full control. You get an exact replication of both the shape and edge angle. You can also use it for woodcarving tools, such as curved gouges and V-tools. Used correctly, there is no alternative method that can give you faster or sharper results. Superior Edge Wet grinding on your Tormek gives you a very sharp edge that will last much longer. A really sharp gouge cuts easily and will give the wood a very fine surface, often there is no need for sanding. Full control With the Turning Tool Setter TTS-100, you get exactly the shape and edge angle you want depending on your turning. Even the length of the side wings can be varied so that the shape of the gouge fits your way of turning. Exact replication Thanks to the exact replication of both the shape and the edge angle, the sharpening will take less than a minute. Since you only remove a tenth of a millimetre at each sharpening, your turning tools will last for years, probably your whole lifetime. Gentle on the steel With the Tormek system the edge is cooled continuously with water and there is no risk of the steel to become overheated and losing its hardness. (PDF Wet or Dry). SVD-185 on a bench grinder If you need to remove a lot of steel fast in order to change the profile or create a smaller edge angle, you can with the ing set BGM-100 also use SVD-185 on a bench grinder. But here you need to pay attention so that you do not burn the edge. After the initial rough shaping on a bench grinder, you move over to the Tormek machine and give the edge the final sharpness. Thanks to the patented Turning Tool Setter TTS-100 you keep exactly the same shape and edge angle. You get the best of two worlds with the same jig system – fastest steel removal and the sharpest edge possible!