Track Clamps, Woodworking Clamp, KMA7520, Set of 2

As some of the other reviewers indicate, the clamps are made from a variety of materials with the main clamping part made from a plastic material which if you consider it, helps prevent damaging the track or denting the workpiece. I've been using these for the past two days on a cabinet project and am pleased with their overall performance. They pretty much eliminate the risk of having the track inadvertently move during a cut. The plastic should hold up to repeated use if you don't over tighten the clamps to the work piece.

Fit perfectly in my Acci-Cut. Works great.

Working out great

Holds real good it's out of the way can't even see it

I've had the Accu-Cut setup for a few years but was never really the happy with it. Things tended to move around a bit if you weren't careful. Being able to clamp the rail to the workpiece insures an accurate cut and great results. Wish I would've bought these clamps right out of the gate when I bought my Accu-Cut system.

Works well no need to over tighten the knobs

Clamps down quickly and easily and holds track firmly in place. If you have the same issue of the track wandering slightly off the line as you are progressing with the saw, this will end that problem and save you money, especially if you do woodworking where perfect, square cuts are required. Kreg obviously knew this was a problem, hence why they sell these clamps.

I have not used this yet but am giving it 3 stars because the main clamp is made from plastic along with tightening knob. I dont see these lasting long just based on those two things.

Ok

Stabile Material bloß die Preise von kreg sind übertrieben teuer

When it’s cold these are a must

Muy prácticas y seguras

裏側だけで固定できるため、通常クランプのように上に出っ張るものがなく、クランプの上を丸鋸が通過できるようになるという素晴らしいアイテムです。 定規を購入する際にはセットでぜひ