Lavievert Puzzle Saver Peel & Stick Adhesive Paper Jigsaw Glue Best Way to Preserve Your Finished Puzzle - 10 Sheets

More than enough to back 60x80cm jigsaw puzzle. Sticks very well and easy to use. I placed the sticky sheets close to edges to start before filling in rest of area with just a slight overlap where the sheets met. All was easy enough but I think I would cut the main sheets in half next time as smaller ones are easier to handle. They can be cut to any size so there is no waste. To unpeel the sticky sides turn over a tiny corner and the two surfaces start to come apart so it is easier to unpeel. Make sure the jigsaw is on a hard surface as it helps to use a rolling pin over all to ensure pieces are completely locked in place. The smoothers used on the sheets after sticking helps a lot, as does a final roll with the rolling pin.

Sticking jigsaw puzzle, easy to use, done what it was meant to do.

I had a personalised jigsaw that I wanted to hang, but was wary of the glue-style puzzle preservers that you apply to the front of the jigsaw. After a lot of research, I chose this product because it is applied to the back of the jigsaw and therefore doesn't ruin the picture. It worked a treat! It is like sticky-back plastic but with superglue-strength adhesion and the jigsaw feels totally solid. I would advise to measure the pieces carefully and mark on the back of the jigsaw with pencil where they are to be applied. The pieces are easily cut to size, and you get more sheets than you need in the pack (which is reassuring in case you cut them wrong!). Take care when applying as the sheets are very strong and if you make a mistake you can't undo it, but there is a tool included to remove any bubbles, which helps in masking any errors! I did not use the included hangers, as I used a clipframe to hang it in. This is a really good product which I would hightly recommend.

Ideal for attaching to back of jigsaws to hang,easy to use.Bought two for grandsons jigsaw easy to hang without being to heavy

OK so these do exactly what they are designed to do and there's no doubt they do it well. My issue though is the value for money, as a product its great but it's so expensive for what it is. I could get a role of parcel tape and overlap and cross cross the back of the jigsaw 3 times over and it would still be a fraction of the cost of these. It's not like this product actually gives the jigsaw any sturdiness either.

Works well, does the job no problems 🙂

Easy to use and sturdy enough for puzzle move around or take it up, really please with this item

Very very useful

Comodi, pratici, se possibile migliorerei l’estetica del gancetto al muro, al momento enorme e poco elegante

This is a puzzle saver adhesive. The backing has graph 1cm lines so that you can get the right cut. The spatulas are quite handy when applying the adhesive film to the back of the puzzle and I'm glad they provided two . The product comes with plastic hanger tabs too which is quite handy for hanging obviously. For a typical 1,000 piece puzzle I had to use six sheets. But the sheets had to be cut out to size. And you will end up with leftover strips. My family likes to do puzzles together and we like to save it and hang in our garage as a collage of puzzles. This is a great way to do that. Besides this product I actually like to put a film of modpodge puzzle paste on the puzzle picture itself so it retains some water moisture protection since it will be in the garage. .

Ottima alternativa alla colla liquida, molto facili da applicare e ritagliare

There were enough sheets for two 1,000 piece puzzles, with 1 full extra sheet and scraps. Hint: When you pull back the clear portion, cut off a bit of the paper backing, so you will be able to see exactly where to place the clear edge. I haven’t yet hung my puzzles so I will give an update on that aspect later. I WILL buy this product again!

We bought this product to hold our puzzles together. We have real wood puzzles, we aren't able to use glue on them to hold the pieces together. This product is perfect!